LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2005 >> Escape Base, 3.0 1, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 573 (Body Panel System - Front End Body Panels -- F250-F550 Super Duty) >> Removal And Installation >> Cowl Panel Grille >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2006 Ford Pickup, 2006 Ford F550 Super Duty, 2006 Ford F450 Super Duty, and 2006 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the windshield wiper arms. For additional information, refer to WIPERS AND WASHERS .
  2. Remove the radio antenna mast.
    • Lift upward on the cover.
      Fig 1: Locating Radio Antenna Mast
      G04645735Courtesy of FORD MOTOR CO.
  3. Remove the cowl top vent panel retaining screws.
    Fig 2: Locating Cowl Top Vent Panel Retaining Screws
    G04645736Courtesy of FORD MOTOR CO.
  4. Raise the hood.
  5. Disconnect the windshield washer hose.
    Fig 3: Disconnecting Windshield Washer Hose
    G04645737Courtesy of FORD MOTOR CO.
  6. Remove the cowl panel weatherstrip.
    Fig 4: Locating Cowl Panel Weatherstrip
    G04645738Courtesy of FORD MOTOR CO.
  7. Remove and discard the cowl top vent panel pushpins.
    Fig 5: Locating Cowl Top Vent Panel Push Pins
    G04645739Courtesy of FORD MOTOR CO.
  8. NOTE: Remove the cowl top vent panel from the center to avoid damage to the locating pins at each outer end of the cowl panels.
    Fig 6: Raising Cowl Top Vent Panel
    G04645740Courtesy of FORD MOTOR CO.
  9. Raise the cowl top vent panel.
  10. Remove the cowl top vent panel.
  11. To install, reverse the removal procedure.