LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2005 >> Escape Base, 3.0 1, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 487 (Automatic Transmission Cooling System - Cd4E) >> Removal And Installation >> Cooler Bypass Valve >> Removal

Cooler Bypass Valve: Removal

WARNING: This page is about a different car, the 2006 Mercury Mariner and 2006 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
  2. Remove the driver side splash shield.
  3. Remove and discard the transmission fluid cooler tube from the pump area of the case.
    • Remove the transmission fluid cooler tube from the transaxle.
  4. Remove the transmission fluid cooler tube bracket bolt.
  5. Disconnect the transmission fluid cooler hose from the auxiliary cooler.
    6. NOTE: Do not remove the steel tube from the converter housing.
  6. Remove the transmission fluid cooler hose from the converter housing and the lower fitting of the radiator. Discard the hose.
  7. Remove the 2 bolts from the lower LH side of the main control cover.
scientia non olet · About LEMON Manuals