Removal and Installation
WARNING: This page is about a different car, the 2011 Mercury Milan, 2011 Lincoln MKZ, and 2011 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the RH front door scuff plate.
- Disconnect the Inertia Fuel Shutoff (IFS) switch electrical connector.
- Remove the 2 bolts and the IFS switch.
- To install, tighten to 2 Nm (18 lb-in).
- To install, reverse the removal procedure.
NOTE:
Do not overtighten the fasteners or damage to the switch will occur.