Pinpoint Test Z: DTC U3002:62
WARNING: This page is about a different car, the 2011 Mercury Milan, 2011 Lincoln MKZ, and 2011 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
- Z1 VERIFY PCM VIN
- Connect the scan tool.
- Ignition ON.
- Enter the following diagnostic mode on the scan tool: Log Viewer.
- Compare the VIN in Log Viewer to the vehicle VIN plate.
- Does VIN in Log Viewer match the vehicle VIN plate?
- Yes : GO to Z2.
- No : RECONFIGURE the PCM. FOLLOW the instructions on the scan tool. CLEAR the DTCs. CYCLE the ignition key. REPEAT the self-test.
- Z2 VERIFY ABS MODULE PART NUMBER
- Retrieve and record the ABS module part number from Log Viewer and verify that the vehicle has the correct ABS module installed.
- Is the correct ABS module installed in the vehicle?
- Yes : CONFIGURE the ABS module. REFER to Programmable Module Installation (PMI) Using the Integrated Diagnostic System (IDS) When the Original Module is NOT Available in MODULE CONFIGURATION -- FUSION MILAN & MKZ article. CLEAR the DTC. CYCLE the ignition key. REPEAT the self-test.
- No : INSTALL a new ABS module. REFER to ANTI-LOCK BRAKE SYSTEM (ABS) MODULE - HYBRID in this service information. CLEAR the DTC. CYCLE the ignition key. REPEAT the self-test.