LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2005 >> Escape Base, 3.0 1, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1624 (Power Brake Actuation -- Brake Booster) >> Removal And Installation >> Brake Booster Travel Sensor - Hybrid >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2011 Mercury Milan, 2011 Lincoln MKZ, and 2011 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the Motor Electronics Cooling System (MECS) expansion tank nut and bolt, position the tank aside.
    • To install, tighten the nut and bolt to 12 Nm (106 lb-in).
    Fig 1: Locating Motor Electronics Cooling System (MECS) Expansion Tank Nut And Bolt
    G07784236Courtesy of FORD MOTOR CO.
  2. Disconnect the brake booster travel sensor electrical connector.
  3. Release the brake booster travel sensor retainer ring and remove the travel sensor.
    Fig 2: Releasing Brake Booster Travel Sensor Retainer Ring
    G06094483Courtesy of FORD MOTOR CO.
  4. To install, reverse the removal procedure.
  5. Following the scan tool instructions, carry out the Multi-Calibration Routine.
scientia non olet · About LEMON Manuals