LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2005 >> Escape Base, 3.0 1, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1507 (Parking Brake System - Parking Brake & Actuation) >> Diagnostic Tests >> Parking Brake >> Pinpoint Tests >> Pinpoint Test A: The Parking Brake Does Not Apply

Pinpoint Test A: The Parking Brake Does Not Apply

WARNING: This page is about a different car, the 2010 Lincoln Town Car. However, it is still accessible from the selected car via links, so may be relevant.

Normal Operation 

When the parking brake control pedal is pressed, the pedal should move a short distance, with more pressure needed to apply the pedal as it gets closer to the floor, until the parking brake shoes are fully applied. When the pedal is pressed, tension is applied to the front parking brake cable. This tension pulls on the LH rear parking brake cable, which is attached to the LH rear parking brake shoe actuator and applies the LH rear brake shoes. At the same time, the tension in the LH rear cable causes the LH rear cable conduit to attempt to straighten out. This straightening effect causes the LH rear cable conduit to pull on the RH rear parking brake cable, which is attached to the RH rear parking brake shoe actuator and applies the RH rear brake shoes.

This pinpoint test is intended to diagnose the following:

PINPOINT TEST A: THE PARKING BRAKE DOES NOT APPLY 

  1. A1 CHECK THE PARKING BRAKE CONTROL 
    • Press the parking brake control pedal.
    • Does the parking brake control pedal move? 
    1. YES  : Go to  A2.
    2. NO  : Go to  A6.
  2. A2 CHECK FOR BROKEN CABLES 
      NOTE: Have an assistant press and release the parking brake pedal to help isolate disconnected cables or cables that do not move.
    • Inspect the front cable, both rear cables, cable equalizers and parking brake shoes or brake shoe actuators for damage and correct connections.
    • Is any damage found or are any cables disconnected? 
    1. YES  : CONNECT the cable(s) or INSTALL new parking brake component(s) as necessary. TEST the system for normal operation.
    2. NO  : Go to  A3.
  3. A3 CHECK THE PARKING BRAKE CABLE ADJUSTMENT 
    1. YES  : ADJUST as necessary. TEST the system for normal operation.
    2. NO  : Go to  A4.
  4. A4 CHECK THE PARKING BRAKE SHOES AND HARDWARE 
    • Remove the rear brake disc, refer to REMOVAL AND INSTALLATION article. Inspect the parking brake shoes and hardware for damage and/or missing components.
    • Is any damage found or are any components missing? 
    1. YES  : INSTALL new components as necessary. REFER to Parking Brake Shoes . TEST the system for normal operation.
    2. NO  : Go to  A5.
  5. A5 CHECK THE PARKING BRAKE SHOE ADJUSTMENT 
    1. YES  : ADJUST as necessary. TEST the system for normal operation.
    2. NO  : INSTALL a new parking brake control. REFER to Parking Brake Control . TEST the system for normal operation.
  6. A6 ISOLATE THE PARKING BRAKE CONTROL AND FRONT PARKING BRAKE CABLE 
      Fig 1: Connector Between Front Parking Brake Cable & Rear Parking Brake Cable
      GF0014000Courtesy of FORD MOTOR CO.
    • Disconnect the front parking brake cable from the LH rear parking brake cable.
    • Press the parking brake control pedal.
    • Does the parking brake control pedal move? 
    1. YES  : Go to  A7.
    2. NO  : Go to  A8.
  7. A7 ISOLATE THE REAR PARKING BRAKE CABLES 
    • Disconnect the rear parking brake cables from the brake shoe actuator cables.
    • While holding the cable conduit, attempt to slide the cable inside the conduit.
    • Does the cable slide freely inside the conduit? 
    1. YES  : INSPECT the parking brake shoes, hardware and backing plate. INSTALL new components as necessary. REFER to Parking Brake Shoes . TEST the system for normal operation.
    2. NO  : INSTALL new rear brake cable(s). REFER to Parking Brake Cable - Rear . TEST the system for normal operation.
  8. A8 ISOLATE THE FRONT PARKING BRAKE CABLE 
    • Disconnect the front parking brake cable and conduit from the parking brake control.
    • While holding the cable conduit, attempt to slide the cable inside the conduit.
    • Does the cable slide freely inside the conduit? 
    1. YES  : INSTALL a new parking brake control. REFER to Parking Brake Control . TEST the system for normal operation.
    2. NO  : INSTALL a new front parking brake cable. REFER to Parking Brake Cable - Front . TEST the system for normal operation.
scientia non olet · About LEMON Manuals