Removal and Installation
WARNING: This page is about a different car, the 2010 Mercury Mariner and 2010 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
- Drain the cooling system. For additional information, refer to COOLING SYSTEM DRAINING, FILLING AND BLEEDING .
- Disconnect the lower radiator hose from the thermostat housing.
- Remove the 2 bolts, thermostat housing cover, O-ring seal and thermostat.
- To install, tighten to 10 Nm (89 lb-in).
- To install, reverse the removal procedure.
- Clean and inspect the O-ring seal. Install a new seal if necessary.
- Fill and bleed the cooling system. For additional information, refer to COOLING SYSTEM DRAINING, FILLING AND BLEEDING .
NOTE:
To install, lubricate the thermostat housing O-ring seal with clean engine coolant.