LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2005 >> Escape Base, 3.0 1, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1416 (Parking Brake System - Parking Brake & Actuation) >> Removal And Installation >> Parking Brake Cable - Rear, RH >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2010 Mercury Mariner and 2010 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
  1. Release the parking brake cable tension. For additional information, refer to PARKING BRAKE CABLE TENSION RELEASE .
  2. Remove the rear brake shoes. For additional information, refer to BRAKE SHOES .
  3. Disconnect the parking brake cable from the cable connector and the equalizer bracket by compressing the cable conduit locking tabs.
  4. Compress the retaining clip and detach the parking brake cable from the exhaust support bracket.
  5. Remove the parking brake cable bracket bolt.
    • To install, tighten to 23 Nm (17 lb-ft).
  6. Compress the rear parking brake cable conduit locking tabs and pull the cable assembly through the brake backing plate.
    Fig 1: Compressing Rear Parking Brake Cable Conduit Locking Tabs
    G06094443Courtesy of FORD MOTOR CO.
  7. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals