LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2005 >> Escape Base, 3.0 1, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1307 (Power Brake Actuation -- Brake Booster) >> Removal And Installation >> Brake Booster Vacuum Sensor - Non-Hybrid

Brake Booster Vacuum Sensor - Non-Hybrid

WARNING: This page is about a different car, the 2010 Mercury Milan, 2010 Lincoln MKZ, and 2010 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the battery. For additional information, refer to REMOVAL AND INSTALLATION .
  2. Remove the 2 brake fluid remote reservoir nuts and position the reservoir aside.
    • To install, tighten the nuts to 7 Nm (62 lb-in).
  3. Disconnect the vacuum sensor electrical connector and remove the vacuum sensor.
  4. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals