LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2005 >> Escape Base, 3.0 1, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1229 (Rear Disc Brake System) >> Removal And Installation >> Rear Disc Brake - Single Rear Wheel (SRW) >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2008 Ford RV Cutaway, 2008 Ford Econoline, 2008 Ford E450 Super Duty, and 2008 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the wheel and tire. For additional information, refer to WHEELS AND TIRES article.
    2. CAUTION: Do not allow the caliper and anchor plate assembly to hang from the brake hose or damage to the hose can occur.
  2. Remove the 2 brake caliper anchor plate bolts and position the brake caliper and anchor plate assembly aside.
    • Support the caliper and anchor plate assembly using mechanic's wire.
    • To install, tighten to 225 Nm (166 lb-ft).
  3. Index-mark the brake disc.
    4. Fig 1: Index-Marking Brake Disc
    GF0012261Courtesy of FORD MOTOR CO.
  4. Remove the brake disc.
  5. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals