Removal And Installation
WARNING: This page is about a different car, the 2008 Ford RV Cutaway, 2008 Ford Econoline, 2008 Ford E450 Super Duty, and 2008 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the ignition coil. For additional information, refer to Ignition Coil-On-Plug .
- Remove the spark plugs.
- To install, tighten to 14 Nm (10 lb-ft).
- Inspect the spark plugs. For additional information, refer to ENGINE SYSTEM - GENERAL INFORMATION article.
- To install, reverse the removal procedure.
- Adjust the plug gap as necessary.
CAUTION:
Only use hand tools when removing or installing the spark plugs or damage can occur to the cylinder head or spark plug.
NOTE:
Remove any foreign material from the spark plug wells with compressed air before removing the spark plugs.
NOTE:
If an original spark plug is used, make sure it is installed in the same cylinder from which it was taken. New spark plugs can be used in any cylinder.