LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2005 >> Escape Base, 3.0 1, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1044 (Anti-Lock Brake System) >> Removal And Installation >> Wheel Speed Sensor Ring - Rear >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2007 Mercury Mariner and 2007 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.

Front wheel drive (FWD) vehicles 

  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING AND LIFTING article.
  2. Remove the rear wheel hub nut.
    • To install, tighten to 290 Nm (214 lb-ft).
  3. Remove the sensor ring from the wheel hub.
  4. To install, reverse the removal procedure.

    5. All wheel drive (AWD) vehicles 

  5. The rear wheel speed sensor ring is integral to the rear axle halfshaft and cannot be repaired separately. For additional information, refer to REAR DRIVE HALFSHAFTS article.
scientia non olet · About LEMON Manuals