LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2005 >> Escape Base, 3.0 1, FWD >> Repair and Diagnosis (Single Page) >> Engine Performance >> Fuel Delivery >> Fuel Tank & Fuel Lines - (Except Hybrid) >> Removal And Installation >> Inertia Fuel Shutoff (IFS) Switch >> Removal and Installation

Removal and Installation

  1. Disconnect the battery ground cable. For additional information, refer to BATTERY, MOUNTING AND CABLES .
  2. Remove the RH lower A-pillar trim panel.
  3. Disconnect the inertia fuel shutoff (IFS) switch electrical connector
  4. Remove the 2 bolts and the IFS switch.
    • To install, tighten to 10 Nm (89 lb-in).
  5. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals