LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2005 >> Escape Base, 3.0 1, FWD >> Repair and Diagnosis (Single Page) >> Engine Performance >> Fuel Delivery >> Fuel Tank & Fuel Lines - (Except Hybrid) >> Removal And Installation >> Fuel Tank Filler Pipe >> Removal

Fuel Tank Filler Pipe: Removal

WARNING: Do not smoke or carry lighted tobacco or open flame of any type when working on or near any fuel-related component. Highly flammable mixtures are always present and may be ignited, resulting in possible personal injury.
WARNING: Do not carry personal electronic devices such as cell phones, pagers or audio equipment of any type when working on or near any fuel-related components. Highly flammable mixtures are present and may be ignited. Failure to follow these instructions can result in personal injury.
WARNING: Fuel in the fuel system remains under high pressure even when the engine is not running. Before repairing or disconnecting any of the fuel system components, the fuel system pressure must be relieved to prevent accidental spraying of fuel causing personal injury or a fire hazard.
WARNING: The fuel in the tank may be pressurized. Remove the fuel tank cap slowly. If a hissing sound is heard, wait until the condition stops before removing the fuel tank filler cap. If these precautions are not followed, fuel may spray and cause personal injury.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING AND LIFTING .
  2. Release the fuel system pressure. For additional information, refer to FUEL SYSTEM-GENERAL INFORMATION .
  3. Disconnect the battery ground cable. For additional information, refer to BATTERY, MOUNTING AND CABLES .
  4. Remove the fuel tank filler cap.
  5. Insert the fuel drain tube special tool into the fuel tank filler pipe until it reaches the fuel tank check valve.
  6. Attach the fuel storage tanker to the fuel drain tube and remove any residual fuel in the fuel tank filler pipe.
  7. Remove the 2 fuel tank filler pipe mounting screws.
  8. Remove the rivets and the fuel tank tube shield.
  9. Remove the remaining fuel tank filler pipe mounting screw.
  10. Disconnect the fuel vapor control tube assembly valve quick connect coupling from the fuel tank filler tube. For additional information, refer to FUEL SYSTEM-GENERAL INFORMATION .
  11. Detach the fuel vapor vent hose retainer clips.
  12. Disconnect the fuel vapor vent hose from the evaporative emissions (EVAP) canister.
  13. Reposition the clamp and disconnect the fuel tank filler pipe hose from the fuel tank.
    • Remove the fuel tank filler pipe as a complete assembly.
scientia non olet · About LEMON Manuals