LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2005 >> Escape Base, 3.0 1, FWD >> Repair and Diagnosis (Single Page) >> Engine Mechanical >> Cooling System (Mechanical) >> Engine Cooling System Specifications & Drive Belt Routing - 3.0L (4V) >> Removal And Installation >> Coolant Pump Belt >> Removal

Coolant Pump Belt: Removal

  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING AND LIFTING .
  2. Remove the bolts and the RH splash shield.
  3. Remove the 2 nuts and the coolant belt pump shield.
  4. Cut and remove the water pump belt.
    • Discard the belt.
      Fig 1: Removing Coolant Belt Pump Shield
      G03898473Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals