LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2005 >> Escape Base, 3.0 1, FWD >> Repair and Diagnosis (Single Page) >> Engine Mechanical >> Cooling System (Mechanical) >> Engine Cooling System Specifications & Drive Belt Routing - 3.0L (4V) >> Removal And Installation >> Accessory Drive Belt >> Removal and Installation

Removal and Installation

  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING AND LIFTING .
  2. Remove the bolts and the RH splash shield.
    • To install, tighten to 7 Nm (62 lb-in).
  3. Using a suitable belt tensioner release tool, rotate the accessory drive belt tensioner counterclockwise and remove the accessory drive belt.
    4. NOTE: Refer to the illustration for correct drive belt routing.
    Fig 1: Removing Accessory Drive Belt
    G03900405Courtesy of FORD MOTOR CO.
  4. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals