LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2005 >> Escape Base, 3.0 1, FWD >> Repair and Diagnosis (Single Page) >> Engine Mechanical >> Cooling System (Mechanical) >> Engine Cooling - (Except Hybrid) >> Removal And Installation >> Water Pump - 2.3L >> Removal and Installation

Removal and Installation

  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING AND LIFTING .
  2. Drain the cooling system. For additional information, refer to COOLING SYSTEM DRAINING, FILLING AND BLEEDING .
  3. Remove the accessory drive belt. For additional information, refer to ACCESSORY DRIVE - 2.3L .
  4. Remove the 3 bolts and the coolant pump pulley.
    • To install, tighten to 25 Nm (18 lb-ft).
  5. Remove the 3 bolts and the coolant pump.
    • Remove and discard the O-ring seal.
    • To install, tighten to 10 Nm (89 lb-in).
  6. To install, reverse the removal procedure.
    • Lubricate the new O-ring seal with clean engine coolant.
  7. Fill and bleed the cooling system. For additional information, refer to COOLING SYSTEM DRAINING, FILLING AND BLEEDING .
scientia non olet · About LEMON Manuals