LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2005 >> Escape Base, 3.0 1, FWD >> Repair and Diagnosis (Single Page) >> Engine Mechanical >> Cooling System (Mechanical) >> Engine Cooling - (Except Hybrid) >> Removal And Installation >> Degas Bottle >> Removal and Installation

Removal and Installation

    All vehicles 

  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING AND LIFTING .
  2. Drain the cooling system. For additional information, refer to COOLING SYSTEM DRAINING, FILLING AND BLEEDING .
  3. Disconnect the radiator-to-degas bottle hose from the degas bottle.

    4. 2.3L vehicles 

  4. Disconnect the degas bottle-to-coolant bypass housing hose.

    5. All vehicles 

  5. Remove the 2 degas bottle nuts.
    • To install, tighten to 6 Nm (53 lb-in).
  6. Lift the degas bottle up and disconnect the degas bottle-to-radiator hose.
    • Remove the degas bottle.
  7. To install, reverse the removal procedure.
  8. Fill and bleed the cooling system. For additional information, refer to COOLING SYSTEM DRAINING, FILLING AND BLEEDING .
scientia non olet · About LEMON Manuals