LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2005 >> Escape Base, 3.0 1, FWD >> Repair and Diagnosis (Single Page) >> Brakes >> Mechanical - Hydraulic >> Front Disc Brake System >> Removal And Installation >> Front Brake Caliper Anchor Plate - Hybrid >> Removal and Installation

Removal and Installation

    NOTE: The following steps must be followed to prevent the accumulator from charging and pressurizing the brake system.
  1. Disconnect the battery. For additional information, refer to BATTERY, MOUNTING AND CABLES .
  2. Remove the battery junction box (BJB) fuses 24 (50A) and 31 (50A).
  3. Remove the brake pads. For additional information, refer to BRAKE PADS .
  4. Remove the 2 brake caliper anchor plate bolts.
    • To install, tighten to 150 Nm (111 lb-ft).
  5. Remove the brake caliper anchor plate.
  6. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals