Removal and Installation

NOTE: If new rear brake shoes and linings are being installed, resurface the brake drums to remove glazing and to provide an equal friction surface from side-to-side. Resurfacing also corrects out-of-round and bell conditions.

Remove the brake drum. For additional information, refer to BRAKE DRUM .
Remove the parking brake lever clip.
Remove the 2 brake shoe retaining clips and the 2 pins.
Remove the upper return spring.
Remove the self-adjuster assembly.
Remove the lower return spring.
Remove the parking brake actuator lever.
Remove the rear brake shoes.
- Apply silicone grease to the brake shoe contact points on the backing plate.
Remove the self-adjuster spring and lever.
Remove the pivot pin.
To install, reverse the removal procedure.
- Adjust the rear brake shoes. For additional information, refer to BRAKE SHOE ADJUSTMENT .