Brake Drum: Removal
CAUTION:
To reduce the possibility of uneven braking, always install new rear brake shoes at both ends of an axle.
- With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING AND LIFTING .
- If the brake drum binds on the brake shoes, retract the brake shoes.
- Move the brake shoe adjuster actuator lever away from the adjuster.
- Rotate the brake shoe adjuster screw upward to retract the brake shoes.
- Remove the brake drum.
CAUTION:
Use of a brake drum puller or a torch is not recommended. Brake drum distortion can result.
NOTE:
If the brake drum is seized to the wheel hub pilot diameter, tap the center of the brake drum between the wheel studs.