LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2005 >> Escape Base, 3.0 1, FWD >> Repair and Diagnosis (Single Page) >> Body & Frame >> Exterior Body Panels >> Bumper System >> Removal And Installation >> Bumper - Rear >> Removal and Installation

Removal and Installation

  1. Remove the rear bumper cover. For additional information, refer to BUMPER COVER - REAR .
  2. Remove the 4 rear bumper nuts.
    • To install, tighten to 25 Nm (18 lb-ft).
  3. Remove the rear bumper.
  4. If necessary, remove the rivets and the rear bumper isolator.
    • Use the special tool to install the new rivets.
  5. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals