LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2005 >> Escape Base, 3.0 1, FWD >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Headlights >> Daytime Running Lamps System >> Diagnosis And Testing >> Daytime Running Lamps (DRL) >> Inspection and Verification

Inspection and Verification

NOTE: When installing a new smart junction box (SJB), it must be reconfigured for this feature if originally equipped. Refer to MODULE CONFIGURATION .
  1. Verify the customer concern by operating the daytime running lamps (DRL) following these steps:
    1. Place the ignition switch in the RUN position.
    2. Place the headlamp switch in the OFF position.
    3. Fully apply the brake.
    4. Release the parking brake.
    5. Place the transmission in DRIVE.
    6. If the DRL does not operate, make sure the SJB is configured for DRL before proceeding to the next step.
  2. Verify the parking lamp operation.
    • Place the headlamp switch in the parking lamps ON position.
      • If the parking lamps do not operate correctly, refer to EXTERIOR LIGHTING .
      • If the parking lamps operate correctly, go to the next step.
  3. Verify the high beam operation.
    1. Place the headlamp switch in the headlamps ON position.
    2. Place the multifunction switch in the high beam position.
      • If the high beams operate correctly and the DRL operation is incorrect, install a new SJB. Refer to MULTIFUNCTION ELECTRONIC MODULES . Test the system for normal operation.
      • If the high beams do not operate correctly, refer to EXTERIOR LIGHTING for correct diagnosis.
scientia non olet · About LEMON Manuals