Engagement Concern: No 1st Gear in Manual 1 Position

ENGAGEMENT CONCERN: NO 1ST GEAR IN MANUAL 1 POSITION (216)

Possible Component	Reference/Action
216 - ROUTINE
Powertrain Control System
PCM, vehicle wiring harnesses, Shift Solenoids A, B, Pressure Control Solenoids B, C	Carry out on-board diagnostic tests. REFER to the INTRODUCTION article in ENGINE PERFORMANCE. Go to PINPOINT TEST A: SHIFT AND TORQUE CONVERTER CLUTCH SOLENOIDS and Go to PINPOINT TEST D: PRESSURE CONTROL (PC) SOLENOIDS (PCA, PCB, PCC) . Repair as necessary. Clear DTCs, road test and rerun on-board diagnostic test.
Incorrect Pressures
High/low pressures	Carry out Line Pressure Test. Refer to SPECIAL TESTING PROCEDURES .
Main Control
Screws not tightened to specification	Tighten to specification.
Separator plate damaged	Inspect for damage. If damaged, install a new separator plate.
Contamination	Disassemble and clean.
Valves, springs damaged, misassembled, missing, stuck or bore damaged	If damaged or parts are missing, install new main control assembly. If misassembled, reassemble correctly. DO NOT stone, file or sand valves. This will remove the anodized finish and may result in further main control or transmission damage.
Filter damaged, missing	Inspect for damage, repair as necessary.
OD Planetary Assembly
Planetary damaged	Inspect for damage. Repair as necessary.
Direct One-Way Clutch
Worn, damaged or assembled incorrectly	Inspect for damage. Repair as necessary.
Low One-Way Clutch
Worn, damaged or assembled incorrectly	Inspect for damage. Repair as necessary.