Removal & Installation
WARNING: This page is about a different car, the 2003 Ford Pickup, 2003 Ford F550 Super Duty, 2003 Ford F450 Super Duty, 2003 Ford Excursion, and 2003 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
Disconnect canister vent solenoid electrical connector. Remove the canister vent solenoid from EVAP canister. A twisting and pulling motion is necessary to remove the canister vent solenoid. See Fig 1. Inspect and install new O-ring seals as necessary. To install, reverse the removal procedure. Perform after repair procedure. See AFTER REPAIR PROCEDURE under EMISSION SYSTEMS & SUB-SYSTEMS.