LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2004 >> Mustang Mach 1, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1658 (Transfer Case - Four Wheel Drive (4WD) Systems -- F250-F550 Super Duty) >> Removal And Installation >> Mode Select Switch (MSS) >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2007 Ford Pickup, 2007 Ford F550 Super Duty, 2007 Ford F450 Super Duty, and 2007 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the mode select switch (MSS) knob.
  2. Remove the bezel from the instrument cluster (IC) finish panel.
    3. Fig 1: Identifying Instrument Cluster Finish Panel
    GF0007474Courtesy of FORD MOTOR CO.
  3. Disconnect the wiring harness connector.
    4. Fig 2: Disconnecting Wiring Harness Connector
    GF0007475Courtesy of FORD MOTOR CO.
  4. Remove the 2 screws and the MSS.
    5. Fig 3: Locating Screws And MSS
    GF0007476Courtesy of FORD MOTOR CO.
  5. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals