- Squeak or grunt-noise from the front suspension, occurs more in cold ambient temperatures. More noticeable over rough roads or when turning
|
- Front stabilizer bar insulators.
|
- Under these conditions, the noise is acceptable. CHECK TSBs.
|
- Clunk-noise from the front suspension, occurs in and out of turns
|
- Loose front struts or shocks.
|
- INSPECT for loose nuts or bolts. TIGHTEN to specifications. REFER to FRONT
in Suspension
.
|
- Clunk-noise from the rear suspension, occurs when shifting from reverse to drive
|
- Loose rear suspension components.
|
- INSPECT for loose or damaged rear suspension components. REPAIR or INSTALL new components as necessary. REFER to REAR - EXCEPT COBRA
or REAR - COBRA
in Suspension
.
|
- Click or pop - noise from the front suspension. More noticeable over rough roads or over bumps
|
- Worn or damaged ball joints.
|
- CARRY OUT a ball joint inspection. INSTALL new ball joints or control arms as necessary. REFER to FRONT
in Suspension
.
|
- Click or pop (FWD vehicles) - noise occurs when vehicle is turning
|
- Worn or damaged ball joints.
|
- CARRY OUT a ball joint inspection. INSTALL new ball joints or control arms as necessary.
|
- Click or snap - occurs when accelerating around a corner
|
- Damaged or worn outboard CV joint.
|
- INSPECT the outboard CV joint and boot. REPAIR or INSTALL a new CV joint as necessary.
|
- Front suspension noise-a squeak, creak or rattle noise. Occurs mostly over bumps or rough roads
|
- Steering components.
- Loose or bent front struts or shock absorbers.
- Damaged spring or spring mounts.
- Damaged or worn control/radius arm bushings.
- Worn or damaged stabilizer bar bushings or links.
|
|
- Rear suspension noise-a squeak, creak or rattle noise. Occurs mostly over bumps or rough roads
|
- Loose or bent rear shock absorbers.
- Damaged spring or spring mounts.
- Damaged or worn control arm bushings.
- Worn or damaged stabilizer bar bushings or links.
|
|
- Shudder-occurs during acceleration from a slow speed or stop
|
- Rear drive axle assembly mispositioned.
|
- CHECK the axle mounts and the rear suspension for damage or wear. REPAIR as necessary.
|
- Incorrect or high CV joint operating angle.
|
- CHECK vehicle ride height is within limits. REPAIR as necessary.
|
- Damaged or worn front suspension components.
|
- CHECK for a loose stabilizer bar, damaged or loose strut/strut bushings or loose or worn ball joints. INSPECT the steering linkage for wear or damage. REPAIR or INSTALL new components as necessary.
|
- Shimmy-most noticeable on coast/deceleration. Also hard steering condition
|
- Excessive positive caster.
|
|