Drive Engine Run-Up (DERU) Load Test
To carry out this test, proceed as follows:
- Block the front and rear wheels.
- Apply the parking brake and the service brake.
- Install a tachometer.
- Shift the transmission into DRIVE, and increase and decrease the engine rpm between an idle to approximately 2000 rpm. Note the engine rpm and, if possible, determine the vibration frequency.
- Repeat the test in REVERSE.
- If the vibration/noise is duplicated when carrying out this test, inspect the engine and transmission or transaxle mounts.
- If the concern is definitely engine speed-related, carry out the Engine Accessory Test to narrow down the source.
- Proceed as necessary.
WARNING:
Block the front and rear wheels, and apply the parking brake and the service brake, or injury to personnel can result.
CAUTION:
Do not carry out the Drive Engine Run-Up (DERU) Load Test for more than five seconds or damage to the transmission or transaxle can result.