Removal and Installation
WARNING: This page is about a different car, the 2006 Ford Pickup, 2006 Ford F550 Super Duty, 2006 Ford F450 Super Duty, and 2006 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
- With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
- Disconnect the battery ground cable. For additional information, refer to BATTERY, MOUNTING AND CABLES .
- Disconnect the fuel pump driver module (FPDM) electrical connector.
- Remove the FPDM nuts.
- To install, tighten to 10 Nm (89 lb-in).
- Remove the FPDM.
- To install, reverse the removal procedure.