LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2004 >> Focus SVT, 2D Hatchback >> Repair and Diagnosis >> External Pages >> Different car >> Section 1435 (Front Suspension - Four Wheel Drive (4WD) -- F250-F550 Super Duty) >> Removal And Installation >> Wheel Studs - Dual Rear Wheel (DRW) >> Installation

Wheel Studs - Dual Rear Wheel (DRW): Installation

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2006 Ford Pickup, 2006 Ford F550 Super Duty, 2006 Ford F450 Super Duty, 2006 Ford Cab & Chassis, and 2005 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the new wheel stud aligning the serrations in the wheel extension made by the original wheel stud.
    Fig 1: Locating Wheel Stud Aligning Position
    G04643168Courtesy of FORD MOTOR CO.
  2. Place 4 washers over the outside end of the wheel stud and thread a standard wheel nut with the flat side against the washers. Tighten the wheel nut until the wheel stud seats against the back side of the wheel extension.
    Fig 2: Installing Wheel Stud
    G03883229Courtesy of FORD MOTOR CO.
  3. Remove the wheel nut and washers.
scientia non olet · About LEMON Manuals