Shift Interlock Solenoid: Service and Repair

Brake Shift Interlock Actuator

Removal
1. Remove the floor console.





2. Disconnect the overdrive (O/D) switch electrical connector (selector lever assembly removed shown).





3. Remove the shift interlock actuator.
1. Remove the bolt.
2. Pull off the knob.
3. Pull out of the push rod.

Installation





1. Install the shift interlock actuator.
1. Install the push rod.
2. Position the knob.
3. Install the bolt.





2. Connect the O/D switch electrical connector (selector lever assembly removed shown).
3. Install the floor console.