LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2004 >> Explorer 4.0 E, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1399 (Engine - 6.0L (99P F450/550) Diesel -- F250-F550 Super Duty) >> In-Vehicle Repair >> Crankshaft Front Seal >> Removal

Crankshaft Front Seal: Removal

WARNING: This page is about a different car, the 2006 Ford Pickup, 2006 Ford F550 Super Duty, 2006 Ford F450 Super Duty, and 2006 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the crankshaft pulley. For additional information, refer to CRANKSHAFT PULLEY .
  2. Punch 2 holes in the seal.
    Fig 1: Identifying Crankshaft Seal
    G03887244Courtesy of FORD MOTOR CO.
  3. Using the special tool, remove and discard the crankshaft seal.
    Fig 2: Locating Crankshaft Seal
    G04648451Courtesy of FORD MOTOR CO.
    4. NOTE: Production engines will not have a wear sleeve.
    Fig 3: Locating Crankshaft Seal Wear Sleeve
    G04648452Courtesy of FORD MOTOR CO.
  4. If equipped, remove and discard the crankshaft seal wear sleeve.
scientia non olet · About LEMON Manuals