LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2004 >> Excursion 6.8 S, RWD >> Repair and Diagnosis (Single Page) >> Engine Mechanical >> Mechanical >> Engine - 6.8L - Excursion & F250-F550 Super Duty >> In-Vehicle Repair >> Crankshaft Rear Seal >> Removal

Crankshaft Rear Seal: Removal

    NOTE: It is not necessary to remove the transmission from the jack.
  1. Remove the flexplate. Refer to FLEXPLATE .
  2. Using the special tools, remove the crankshaft oil slinger.
    Fig 1: Removing Crankshaft Oil Slinger Using Special Tools
    G02771464Courtesy of FORD MOTOR CO.
  3. Using the special tools, remove the crankshaft rear seal.
    Fig 2: Removing Crankshaft Rear Seal Using Special Tools,
    G02771465Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals