LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2004 >> Excursion 6.8 S, RWD >> Repair and Diagnosis (Single Page) >> Engine Mechanical >> Cooling System (Mechanical) >> Engine Cooling System - Excursion & F250-F550 Super Duty >> Removal And Installation >> Water Pump - Gasoline Engines >> Removal

Water Pump - Gasoline Engines: Removal

  1. Drain the cooling system. Refer to COOLING SYSTEM DRAINING, FILLING AND BLEEDING .
  2. Remove the engine cooling fan and clutch. Refer to COOLING FAN - BLADE, CLUTCH AND SHROUD, 5.4L, 6.8L .
  3. Remove the drive belt.
  4. Remove the coolant pump pulley.
    1. Remove the bolts.
    2. Remove the coolant pump pulley.
      Fig 1: Removing Coolant Pump Pulley
      G02772981Courtesy of FORD MOTOR CO.
  5. Remove the bolts.
    Fig 2: Removing Bolts
    G02772982Courtesy of FORD MOTOR CO.
  6. Remove the (A) coolant pump from the (B) cylinder block.
    • Clean and inspect the mating surfaces.
      Fig 3: Removing Coolant Pump From Cylinder Block
      G02772983Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals