LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2004 >> Excursion 6.8 S, RWD >> Repair and Diagnosis (Single Page) >> Engine Mechanical >> Cooling System (Mechanical) >> Engine Cooling System - Excursion & F250-F550 Super Duty >> Removal And Installation >> Water Pump - Gasoline Engines >> Installation

Water Pump - Gasoline Engines: Installation

    CAUTION: Vehicle cooling systems are filled with Motorcraft Premium Gold Engine Coolant. Do not mix coolant types.
  1. Install the coolant pump.
    1. Lubricate the new O-ring seal using engine coolant and install the O-ring seal onto the coolant pump.
    2. Position the coolant pump into the engine block.
    3. Install the bolts.
      Fig 1: Installing Bolts
      G02772984Courtesy of FORD MOTOR CO.
  2. Position the pulley onto the coolant pump and install the bolts.
    Fig 2: Positioning Pulley Onto Coolant Pump
    G02772985Courtesy of FORD MOTOR CO.
  3. Install the accessory drive belt. Refer to SPECIFICATIONS & DRIVE BELT ROUTING .
  4. Install the fan and fan clutch. Refer to COOLING FAN - BLADE, CLUTCH AND SHROUD, 5.4L, 6.8L .
  5. Refill the cooling system. Refer to COOLING SYSTEM DRAINING, FILLING AND BLEEDING .
scientia non olet · About LEMON Manuals