LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2004 >> Excursion 6.8 S, RWD >> Repair and Diagnosis (Single Page) >> Electrical >> Gauges >> Instrument Panel & Console -- Excursion & F250-F550 Super Duty >> Removal And Installation >> Instrument Panel - Center Finish Panel >> Removal and Installation

Removal and Installation

  1. Remove the instrument panel cluster finish panel. Refer to INSTRUMENT PANEL - CLUSTER FINISH PANEL .
  2. Remove the screws and the utility hook or if equipped, remove the dual fuel bezel.
    • If equipped with the dual fuel switch bezel, disconnect the electrical connector.
      Fig 1: Disconnecting Electrical Connector
      G02774325Courtesy of FORD MOTOR CO.
    3. NOTE: Open the ashtray/beverage holder to gain access to the lower beverage holder screws.
    Fig 2: Remove lower ashtray/beverage holder screws
    G02774326Courtesy of FORD MOTOR CO.
  3. Remove the lower ashtray/beverage holder screws.
  4. Remove the ashtray/beverage holder.
    1. Remove the upper screws.
    2. Remove the ashtray/beverage holder.
      Fig 3: Removing Ashtray/Beverage Holder
      G02774327Courtesy of FORD MOTOR CO.
  5. Remove the instrument panel center finish panel.
    1. Remove the screws.
    2. Remove the instrument panel center finish panel.
      • Disconnect the electrical connector.
        Fig 4: Disconnecting Electrical Connector
        G02774328Courtesy of FORD MOTOR CO.
  6. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals