Driveshaft - Front: Removal

Raise and support the vehicle. For additional information, refer to JACKING & LIFTING .
Remove the 4 bolts and transfer case skid plate, if equipped.

Fig 1: Removing Transfer Case Skid Plate
Courtesy of FORD MOTOR CO.
Index-mark the front driveshaft to the front axle flange and at the transfer case flange.

Fig 2: Identifying Index-Mark Front Driveshaft
Courtesy of FORD MOTOR CO.

Fig 3: Indexing Front Axle Flange
Courtesy of FORD MOTOR CO.
Remove and discard the fasteners.
1. Remove and discard the bolts.
2. Remove and discard the U-joint retainers.
Fig 4: Disconnecting U-Joint Retainers And Bolts
Courtesy of FORD MOTOR CO.
Remove and discard the four bolts.

Fig 5: Disconnecting Four Bolts
Courtesy of FORD MOTOR CO.

NOTE: Wrap electrical tape around the bearing cups to prevent them from falling off the U-joint spider.

Fig 6: Removing Front Driveshaft

Courtesy of FORD MOTOR CO.

Remove the front driveshaft.
- Compress and separate the front driveshaft from the front axle, then separate the driveshaft from the transfer case.