Pinpoint Test E: Adjustable Pedal Moves Rearward Only
- E1 ISOLATE SWITCH
- Disconnect: Adjustable Pedal Switch C2089.
- Measure the resistance across switch terminals 7 and 3.
- Is the resistance less than 5 ohms?
- Yes : GO to E2.
- No :INSTALL a new switch. TEST the system for normal operation.
- E2 CHECK GROUND CIRCUIT FOR OPEN
- Measure the resistance between C2089-3, circuit 57 (BK) and ground.
- Is the resistance less than 5 ohms?
- Yes : GO to SYMPTOM CHART - ADJUSTABLE PEDAL WITHOUT MEMORY .
- No :REPAIR the open in circuit 57 (BK).