Removal and Installation

NOTE: The 60 percent seat is shown, 40 percent seat similar.

Remove the 60/40 percent rear seat. Refer to REAR SEAT - 60/40, CREW CAB .
Remove the two inner bolts from the back side of the center support.

Fig 1: Removing Inner Bolts From Back Side Of Center Support
Courtesy of FORD MOTOR CO.
Separate the 40 percent seat and the 60 percent seat from the center support.

Fig 2: Separating 40 Percent Seat And 60 Percent Seat From Center Support
Courtesy of FORD MOTOR CO.
Remove the side shield and handle.
1. Remove the side latch shield screw.
2. Remove the side latch shield.
3. Remove the cushion release handle screw.
4. Remove the cushion handle.
  
  Fig 3: Removing Side Shield And Handle
  Courtesy of FORD MOTOR CO.
Pry the side shield to release the three clips and remove the shield.

Fig 4: Prying Side Shield To Release Three Clips
Courtesy of FORD MOTOR CO.
Remove the two backrest bolts and remove the backrest assembly.

Fig 5: Removing Backrest Assembly Bolts
Courtesy of FORD MOTOR CO.
To install, reverse the removal procedure.