Removal and Installation

From the bottom of the seat backrest, push the seat backrest upward, then pull the bottom outward and remove from vehicle.

Fig 1: Pulling Bottom Outward
Courtesy of FORD MOTOR CO.
Position the seat cushions back, then remove the bolts.

Fig 2: Removing Bolts
Courtesy of FORD MOTOR CO.
Remove the bolt.

Fig 3: Removing Bolt
Courtesy of FORD MOTOR CO.
Remove the nut and bolt.

Fig 4: Removing Nut And Bolt
Courtesy of FORD MOTOR CO.
Remove the nut.

Fig 5: Removing Nut
Courtesy of FORD MOTOR CO.
To install, reverse the removal procedure.
Check the active restraint system for correct operation. Refer to SAFETY BELT SYSTEM .
- Make sure the safety belt webbing is not twisted prior to installation.