LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2004 >> Excursion 6.8 S, RWD >> Repair and Diagnosis (Single Page) >> Body & Frame >> Exterior Body Panels >> Body Panel System - Front End Body Panels -- Excursion & F250-F550 Super Duty >> Removal And Installation >> Fender >> Removal

Removal And Installation: Fender: Removal

  1. Support the hood using a prop rod.
  2. Disconnect the hood lift (16C826).
    Fig 1: Disconnecting Hood Lift
    G02773495Courtesy of FORD MOTOR CO.
  3. Remove the headlights and turn signals; for additional information, refer to EXTERIOR LIGHTING .
  4. Remove the screws at the lower edge of the front fender (16006) securing the splash shield.
    Fig 2: Removing Screws At Lower Edge Of Front Fender
    G02773496Courtesy of FORD MOTOR CO.
  5. Remove the running board, if so equipped; for additional information, refer to EXTERIOR TRIM AND ORNAMENTATION .
  6. Remove the pushpins at the rear lower edge of the front fender.
  7. Remove the bolts securing the lower rear of the front fender.
    Fig 3: Removing Bolts Securing Lower Rear Of Front Fender
    G02773497Courtesy of FORD MOTOR CO.
  8. Remove the fender-to-radiator grille opening support retaining bolts.
    Fig 4: Removing Fender-To-Radiator Grille Opening Support Retaining Bolts
    G02773498Courtesy of FORD MOTOR CO.
  9. Remove the fender-to-radiator support retaining screws.
    Fig 5: Removing Fender-To-Radiator Support Retaining Screws
    G02773499Courtesy of FORD MOTOR CO.
  10. Open the door, then remove the fender retaining bolts.
    Fig 6: Removing Fender Retaining Bolts
    G02773500Courtesy of FORD MOTOR CO.
  11. Remove the upper fender retaining bolts.
    Fig 7: Removing Upper Fender Retaining Bolts
    G02773501Courtesy of FORD MOTOR CO.
  12. Remove the hood support bolt.
    Fig 8: Removing Hood Support Bolt
    G02773502Courtesy of FORD MOTOR CO.
  13. Remove the front fender.
scientia non olet · About LEMON Manuals