LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2004 >> Excursion 6.8 S, RWD >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Seats >> Seat System -- Excursion & F250-F550 Super Duty >> Removal And Installation >> Rear Seat Cushion - Excursion, Second Row >> Installation

Rear Seat Cushion - Excursion, Second Row: Installation

  1. Release the tension on the push nuts to allow the cushion studs to move freely.
    Fig 1: Releasing Tension On Push Nuts
    G02773947Courtesy of FORD MOTOR CO.
  2. Position the seat cushion to the seat riser, then loosely install the nuts.
    Fig 2: Positioning Seat Cushion To Seat Riser
    G02773948Courtesy of FORD MOTOR CO.
    3. NOTE: Make sure the bumper pins are centered in the holes of the cushion frame.
    Fig 3: Aligning Cushion Frame To Bumper Pins
    G02773949Courtesy of FORD MOTOR CO.
  3. Align the cushion frame to the bumper pins.
    4. NOTE: Make sure the seat cushion is closed and positioned as if it were installed.
    Fig 4: Tightening Nuts
    G02773950Courtesy of FORD MOTOR CO.
  4. Tighten the nuts.
  5. Check the seat cushion latch for correct operation.
  6. Install the seat. Refer to REAR SEAT - EXCURSION, SECOND ROW .
scientia non olet · About LEMON Manuals