Removal (Dual Rear Wheels)

Raise and support vehicle. Remove wheel.
On models with forward-of-axle brake calipers, remove stone shield. See Figure. On all models, remove anchor plate and caliper assembly. See DISC BRAKE CALIPERS & PADS .
Remove axle shaft retaining bolts and axle shaft. See Fig 1. Remove and discard the axle shaft "O" ring seal. See Fig 2.

NOTE: Ensure that the drive tangs on the special tool engage the four slots of the hub nut.

On F350 with Dana axle, using Wheel Hub Nut Socket (T88T-4252-A), or equivalent, remove hub nut. See Fig 3.
On F450 and F550 with Ford axle, using a suitable socket, and in correct rotation, remove hub nut.
On all models, remove outer bearing. Remove hub and rotor assembly. Remove rotor-to-hub bolts and separate rotor from hub.
Inspect the rear hub for cracks and damage around the bolt holes. Check for oversized bolt holes.

Fig 1: Removing Axle Shaft

Courtesy of FORD MOTOR CO.

Fig 2: Identifying Rear Axle Shaft "O" Ring

Courtesy of FORD MOTOR CO.

Fig 3: Removing Rear Wheel Hub Nut (F350 - Dana Axle)

Courtesy of FORD MOTOR CO.