P0243: Supercharger (Boost) Bypass Solenoid Circuit Malfunction
P0243 - SUPERCHARGER (BOOST) BYPASS SOLENOID CIRCUIT MALFUNCTION
| Description: | The PCM monitors the supercharger (boost) bypass (SCB) solenoid circuit for an electrical failure. The test fails when the signal moves outside the minimum or maximum allowable calibrated parameters for a specified SCB solenoid duty cycle (100% or 0%) by PCM command. | ||
| Possible Causes: |
|
||
| Diagnostic Aids: | Disconnect SCB solenoid. Connect test lamp to SCB solenoid harness connector. Cycle SCB driver in PCM by Output Test Mode. Test lamp cycle on and off - SCB solenoid is suspect. Test lamp always on - SCB signal short in harness or PCM. Test always off - SCB signal or VPWR open in harness or PCM. | ||
| Application | Key On Engine Off | Key On Engine Running | Continuous Memory |
| All | GO to PINPOINT TEST KJ: SUPERCHARGER BYPASS CONTROL Step 5. | ||