Engine Controls - Pinpoint Test JB: Secondary Ignition (Cop) Through Pinpoint Test KD: Electric Exhaust Gas RECIRCULATION (EEGR) System - CNG, Flex-Fuel & Gasoline

• Pinpoint Test JB: Secondary Ignition (COP)
  • Introduction
  • Test Procedure
• Pinpoint Test JC: Secondary Ignition (Coil Pack)
  • Introduction
  • Test Procedure
• Pinpoint Test JD: Crankshaft Position (CKP) Sensor
  • Introduction
    • Notes
    • Powertrain Control Module (PCM) Connector
  • Test Procedure
• Pinpoint Test JE: Integrated Ignition Coil Pack A, B or C Failure
  • Introduction
    • Notes
    • Pinpoint Test Schematics and Connectors
  • Test Procedure
• Pinpoint Test JF: Integrated Ignition Coil On Plug Coil A Through J Failure
  • Notes
  • Introduction
  • Test Procedure
• Pinpoint Test JH: Tachometer Signal Output CTO
  • Introduction
    • Notes
    • Powertrain Control Module (PCM) Connector
  • Test Procedure
• Pinpoint Test KA: Fuel Pump Relay
  • Introduction
    • Notes
    • Powertrain Control Module (PCM) Connector
  • Test Procedure
• Pinpoint Test KB: Fuel Pump Driver Module
  • Introduction
    • Notes
    • Powertrain Control Module (PCM) Connector
  • Test Procedure
• Pinpoint Test KC: Fuel Shutoff Valve Relay
  • Introduction
    • Notes
    • Powertrain Control Module (PCM) Connector
    • Typical Schematic
  • Test Procedure
• Pinpoint Test KD: Electric Exhaust Gas Recirculation (EEGR) System
  • Introduction
    • Notes
    • Powertrain Control Module (PCM) Connector
  • Test Procedure