Removal and Installation

Disconnect the battery ground cable.
Remove the RH cowl side trim panel. Refer to INTERIOR TRIM AND ORNAMENTATION .
Disconnect the electrical connector.

Fig 1: Disconnecting Electrical Connector
Courtesy of FORD MOTOR CO.
Remove the inertia fuel shutoff switch.
1. Remove the bolts.
2. Remove the inertia fuel shutoff switch.
  
  Fig 2: Removing Inertia Fuel Shutoff Switch
  Courtesy of FORD MOTOR CO.
To install, reverse the removal procedure.

Fig 3: Connecting Electrical Connector

Courtesy of FORD MOTOR CO.