Inspection and Verification
- Verify the customer concern by operating the horn system.
- Visually inspect for obvious signs of mechanical or electrical damage.
Courtesy of FORD MOTOR CO.
- If the concern remains after the inspection, connect the diagnostic tool to the data link connector (DLC) located beneath the instrument panel, and select the vehicle to be tested from the diagnostic tool menu. If the diagnostic tool does not communicate with the vehicle:
- check that the program card is correctly installed.
- check the connections to the vehicle.
- check the ignition switch position.
- If the diagnostic tool still does not communicate with the vehicle, refer to the diagnostic tool manual.
- Carry out the diagnostic tool data link test. If the diagnostic tool responds with:
- SCP, UBP or ISO circuit fault; all electronic control units no response/not equipped, refer to
MODULE COMMUNICATIONS NETWORK
.
- No response/not equipped for vehicle security module, refer to
MULTIFUNCTION ELECTRONIC MODULE
.
- System passed, retrieve and record the continuous diagnostic trouble codes (DTCs), erase the continuous DTCs and carry out self-test diagnostics for the vehicle security module.
- If the DTCs retrieved are related to the concern, go to the VEHICLE SECURITY MODULE DIAGNOSTIC TROUBLE CODE (DTC) INDEX to continue diagnostics.
- If no DTCs related to the concern are retrieved, proceed to the Symptom Chart to continue diagnostics.