LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2004 >> Excursion 6.8 S, 4WD >> Repair and Diagnosis (Single Page) >> Drivelines & Axles >> Locking Hubs >> Four-Wheel Drive Systems - Excursion & F250-F550 Super Duty >> Removal And Installation >> Hublock Vacuum Reservoir >> Removal and Installation

Removal and Installation

  1. Disconnect the vacuum line connector from the hublock vacuum reservoir.
    Fig 1: Disconnecting Vacuum Line Connector From Hublock Vacuum Reservoir
    G02776712Courtesy of FORD MOTOR CO.
  2. Working through the RH front wheel opening, remove the retaining nuts.
    Fig 2: Removing Retaining Nuts
    G02776713Courtesy of FORD MOTOR CO.
  3. Remove the hublock vacuum reservoir.
  4. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals