Driveshaft - Front: Installation

NOTE: Install the front driveshaft with the index marks aligned.

NOTE: An extension must be used to tighten the driveshaft to transfer case bolts. Extensions change the calibration of the torque wrench. Use the torque wrench manual to calculate the correct settings.

NOTE: Install new bolts and retainers.

Fig 1: Removing Procedure (1 Of 3)

Courtesy of FORD MOTOR CO.

Fig 2: Removing Procedure (2 Of 3)

Courtesy of FORD MOTOR CO.

Fig 3: Removing Procedure (3 Of 3)

Courtesy of FORD MOTOR CO.

To install, reverse the removal procedure.