Removal and Installation

NOTE: The roof opening panel must be initialized when repairs are carried out on any part of the roof opening panel, including: whenever the roof opening panel has been removed from the roof opening panel assembly, a new roof opening panel motor/module has been installed, or when a new roof opening panel assembly has been installed. Refer to ROOF OPENING PANEL MOTOR INITIALIZATION .

Position the roof opening panel in the vent position.
Remove the four roof opening panel bolts.

Fig 1: Removing Four Roof Opening Panel Bolts
Courtesy of FORD MOTOR CO.
Remove the roof opening panel from the outside of the vehicle by lifting up and out.

Fig 2: Removing Roof Opening Panel From Outside Of Vehicle By Lifting Up And Out
Courtesy of FORD MOTOR CO.
To install, reverse the removal procedure.
- Adjust the roof opening panel. Refer to ROOF OPENING PANEL ALIGNMENT - HEIGHT ADJUSTMENT and ROOF OPENING PANEL ALIGNMENT - HORIZONTAL ADJUSTMENT .